Autor Thema: Ein Vorschlag von Aquapulser ?  (Gelesen 2077 mal)

Thorsten

  • Gast
Ein Vorschlag von Aquapulser ?
« am: 02. Juli 2014, 10:18:39 »
Auf der Aquapulser Webseite unter research findet man (unter anderem):

Zitat
The permanent magnet / pulsed DC electromagnet motor - generator is based upon simple physics that a high school student with a good working knowledge of auto mechanics and basic physics can build

The Pulsed DC Magnet motor - generator consist of two opposing disk, a rotor and a stator. The rotor is connected to a shaft that allows it to rotate. The Rotor has a fixed number of permanent magnets 4, 6, 8 etc arranged equidistant around the circumference of the rotor which faces the stator. The stator is fixed in position next to the rotor but independent of the shaft. Mounted on the stator are an equal number of electromagnets (coils with soft iron core) that are arranged directly opposite the permanent magnets of the rotor.

As the rotor rotates, the permanent magnets come into alignment with the electromagnets. During this phase the permanent magnets are attracted to the iron, steel core of the electromagnets. Torque is provided to the shaft by the magnetic attraction of the permanent magnet and the iron, steel core. No power is consumed. This is the Attraction Phase of the Power Cycle.

As the permanent magnet rotates past the center of the electromagnet, a power pulse is fired through the electromagnet. The like polarity of the electromagnet and the permanent magnet cause the permanent magnet to be repelled. The RPG 4700 in combination with a HV spark trigger such as ignition coil or pulse transformer can be used as the power pulse source. Torque is provided to the shaft by means of the magnetic flux of the permanent magnet and the magnetic field generated by the electromagnet. Power is consumed for only a brief [milliseconds] period of time. The power pulse is delivered at the optimum time for the optimum duration by an infrared laser and photo detector switching system. This is the Repulsion Phase of the Power Cycle. The greater the discharge impulse current of the power pulse, the stronger the torque, making the RPG 4700 ideal for use in such motors as the unit in combination with an ignition coil does not consume more than 38 watts at maximum load.

Most of the work, power delivered to the shaft in the form of torque, is done by the permanent magnets. Because power is consumed for only a brief period of time upon each alignment of the permanent magnet and electromagnet, very little power is necessary to run the motor-generator, making it highly efficient. Pick-up coils wound around the electromagnet utilize the collapsing magnetic field [back EMF] of the power pulse to generate a current that can be employed to recharge secondary batteries while a small DC generator connected to the rotor powers an additional load.

Für mich hört sich das eigentlich sehr nach dem Lutec-Setup an (auch wenn John Christie nie so recht sich im Detail ausgelassen hat), von welchem ich überzeugt bin, dass es funktioniert hat.

John Christies Einlassung zur Funktionsweise hier: http://www.rexresearch.com/christie/christie.htm

Die Aquapulser Seite hier : http://www.aquapulser.com/performance_ignition/research.html

Ich werd mit einem Puls-Motor nicht anfangen, weil ich einfach zu faul bin, und 'ne Niete, wenn es zu Elektrik kommt, aber vom Gefühl her halte ich das für einen Weg, den man auch gehen könnte.

Aber was weiß ich schon....  ;)



Schön ist, wie Johann Grander das mal zusammen fasste

--> https://www.youtube.com/watch?v=lIS5oHuolUk
Nur die ersten 2 Minuten mal hören !